Advantage Premium Super Puff Additive can be added to Advantage, Super Advantage and Tourniquet plastisol ink.
Recommended use by weight, ADD 2% for matte finish and 10% additive for puff effect
This allows maximum with minimal change to color compared to regular puff additive. Testing should be done for cure and dye migration.
Flash: 220F
Cure: 320F
Bleed Resistance : Varies by ink
Build Up : Low
Finish: Satin
Shelf Life: 24 months+
Substrates: 100% cotton, 50/50. cotton/ poly blends, some synthetics and some 100% Poly
Mesh Selection: 24 -110
Tension: 15-20 acceptable, 25-35 recommended
Squeegee: 60, 70 or 70/90/70 durometer
Squeegee Pressure: Avoid excess pressure
Squeegee speed: Medium
Curable Reducer: Not recommended
Stencil: CBX7500 or CBX7700 recommended or any emulsion or capillary film.
WashUp: ECO3000 or ECO4440 or any ink degrader.
Avoid contact with eyes, skin and clothes. Avoid breathing vapor or mist. Do NOT swallow. Consult SDS Safety Data Sheet.
Printing Tips:
- Use consistent, high-tensioned screen mesh and sharp edged squeegees for best print results
- Different effects may be achieved through the use of multiple passes, flash curing, thick screen stencils and overprinting with standard and specialty inks
- In multi-color printing, flash the puff prior to overprinting
- Best results when printed directly onto fabric
- For Pantone® colors choose the Pantone® color two shades darker as the color will lighten up
- Mix up to 30% by weight for a maximum puff effect
- Mix up to 2% by weight to reduce gloss of plastisol inks
- If printing a large area, lightweight fabric may pucker. To alleviate puckering, print a mezzotint or dot pattern (an 80 percent solid)
FIRST AID: In case of contact, flush with plenty of water for at least 15 minutes. If symptoms are severe or persist, get medical attention.. If inhaled remove to fresh air, if breathing is difficult give oxygen and get medical attention.
