FEATURES 
Phantom BlackTM 716 is a non-phthalate, high pigment, fast flashing, low tack, high performance plastisol screen printing ink. Phantom BlackTM 716 provides a deep black color that is very creamy, short bodied and is easy to print on automatic or manual presses. Phantom BlackTM  716 achieves excellent penetration into fabrics when printing through fine mesh counts.

SPOT FLASHING
Phantom BlackTM 716 will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used.  In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift-off, but not totally fused.  Final fusing or curing should occur in the dryer.

IMPORTANT INFORMATION
Phantom BlackTM 716 was formulated to make printing opaque black easy, so hand printing is less tiring. The result is improved operator performance. Automatic equipment can be adjusted to lower pressure settings, thus improving screen life and squeegee durability. Phantom BlackTM 716 prints so easily that a finer screen mesh can be used to achieve the same opacity as what you would expect from other opaque black inks at lower mesh counts. Phantom BlackTM 716 is not a color-mixing black ink.

Fibrillation can occur when printing on some cotton fabrics, especially when printing through finer mesh counts. Adding any reducers or additives can lower bleed resistance, reduce opacity, or increase cure times of the ink.  STIR the ink prior to printing on press and after addition of reducers or additives. Test dryer temperatures and wash test printed product before and during a production run. 

RECOMMENDED FABRICS 100% Cotton 50/50 Cotton/Polyester Blends Some Polyesters INK

APPLICATION Phantom BlackTM 716 should be used right from the container  without any modifications

ADDITIVES If modification is necessary, use 1% to 5% by weight 1110 Curable Reducer

SCREEN MESH 60-230 t/in (24-90 t/cm) monofilament

CURE TEMPERATURES 325ºF (163ºC) entire ink film

EMULSION Any direct or indirect emulsion  or capillary film in the 35 to 70  micron range

SQUEEGEE 60-70 Durometer Sharp edge CURE TEMPERATURES 325ºF (163ºC) entire ink film

CLEAN-UP Any eco-friendly plastisol screen wash

STORAGE OF INK CONTAINERS 65º to 90ºF (18º to 32ºC) Avoid storage in direct sunlight Keep containers well sealed