• FlexCure
• Ultra Bleed resistant with excellent opacity
• Mesh: 60 to 230 
• Fast Flashing
• Substrates: Cotton/Poly blends & 100% Polyesters.

7041 Paramount White™ will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift o , but not totally fused. Totally fusing the underprint may cause inter-coat adhesion problems with the inks printed on top. Final fusing or curing should occur in the dryer.

7041 Paramount White™ is an ultra low bleed ink, not a non-bleed ink. On some types of fabric, bleeding or dye migration may occur. Always test print the fabric to be printed before beginning production. It is best to do some long term testing on fabrics to determine if they are going to bleed. Bleeding or dye migration may not occur right away.

Adding any reducers or additives can lower the bleed resistance, opacity, or increase cure times of ink. STIR the ink prior to printing on press and after addition of reducers or additives.

Excessive squeegee pressure, when using 7041 Paramount White™, will drive the ink through the fabric, making the ink look less opaque. Again, adding too much reducer will also cause loss of opacity.

Test dryer temperatures and wash test printed product before and during a production run.

Ghosting, or fabric discoloration may occur when using this product on some 100% cotton fabrics. Always test for ghosting, dye or pigment migration or bleeding on any 100% cotton fabric before beginning production.

RECOMMENDED FABRICS
Cotton/Polyester Blends & 100 polyesters

INK APPLICATION
White should be used right from the container without any modications

ADDITIVES
If modification is necessary, use 1% to 10% by weight of 1099 Low Bleed Curable Reducer

SCREEN MESH: 60-230 

EMULSION: Any direct or indirect emulsion or capillary

SQUEEGEE: 65-75 durometer, Sharp edge

CURE TEMPERATURES
275F to 325F the entire ink film. Fusing at a lower temperature may require a longer dryer retention time.

CLEAN UP: Any eco-friendly plastisol screen wash

STORAGE OF INK CONTAINERS
65º to 90ºF
Avoid storage in direct sunlight
Keep containers well sealed

ICC White Comparison Sheet

Download TDS: Technical Data Sheet

Recommendations and statements made are based on International Coatings’ research and experience. Since International Coatings does not have any control over the conditions of use or storage of the product sold, International Coatings cannot guarantee the results obtained through use of its products. All products are sold and samples given without any representation of warranty, expressed or implied, of tness for any particular purpose or otherwise, and upon condition that the buyer shall determine the suitability of the product for its own purpose. This applies also where rights of third parties are involved. It does not release the user from the obligation to test the suitability of the product for the intended purpose and application.