Shelf life: 12 Months

High Solids: 41% Allows high definition and long lasting durable stencils.

Viscosity: 9,0000 CPS - Medium Viscosity

Faster Exposure times : 3 to 5 x faster then diazo emulsions.

Extremely durable: Yet Very easy to reclaim Long Life

Recommended Inks : Plastisol , also works with Discharge & Waterbased inks with addition of optional diazo.

Sensitizer : Pre-sensitized SBQ emulsion, ready to use straight from container, NO Mixing!

Handling: Handle under yellow lights. Avoid UV exposure , sunlight, fluorescent lighting, overhead lights, etc.

Mesh Preparation: 

It is very important to remove all contamination, residual inks, cleaning chemistry, or general dirt and dust. 

SCP708 Haze Remover will remove residual ink and/or emulsion.

SCP623 Screen Degreaser will help eliminate any further contaminants. Completely dry the screen before coating.

Coating: Use a clean dry coating trough that has a nick free surface for smooth coating.

•  Apply one or two coats of emulsion to the print side. Rotate the frame 180 degrees and apply one or two coats of emulsion to the squeegee side.

•  Additional coats may be added to the print side if thicker stencils are required.

Drying: Dry the coated screen horizontally with the print side down in a clean light safe area. The following will help to ensure complete drying:

•  86° to 104° degrees

•  30% to 50% relative humidity

•  Good air circulation

The use of a screen drying cabinet with heated airflow can help in maintaining these conditions.

Clean the film positives and vacuum frame glass prior to exposure to minimize pinholes.

Exposure is affected by mesh color, emulsion type, coating thickness, lamp type and the age of the bulb itself.

For best results use an exposure calculator to determine the correct exposure time.

Note: The use of film positives that are either frosted or have weak black density can reduce resolution and definition qualities of the coated screen.

Exposure Times

2 coats outside / 1 coat inside on 230 yellow mesh

18 seconds Vastex E2000 High Output LED Exposure unit

30 seconds Vastex E200 LED Exposure Unit

4:14  minutes Vastex E100 Black UV Bulbs 4 ea @ 20w

Washout Image Area: 

Gently spray both sides of the screen with cold to lukewarm water, wait a few seconds to allow emulsion to soften then wash print side of screen until image is fully open.

Rinse both sides thoroughly and dry.

The use of a drying cabinet or fans is recommended to dry the screen. 

Use a pressure washer on fan spray for developing the screen.

Use ECO2770 Ink Degrader or ECO5000 TKO One Step Ink Degrader & Emulsion Remover to remove all excess ink from the frame.

Remove the emulsion with SCP625 Ready to Use emulsion remover or SCP650 Concentrated emulsion remover in dip tank.

UseSCP708 to remove haze and ghost if required.

Degrease with SCP623, rinse both sides thoroughly and let dry.

Optional Diazo for waterbased and discharge

Suitable for use with water based and discharge inks when diazo is added. 

Add only one third of a bottle of water to diazo bottle and shake well before adding to emulsion.

Increase Exposure time by 25% with addition of diazo to emulsion

Store the emulsion in a cool dry area. Pre-sensitized emulsion has a minimal shelf life of at least one year when stored at room temperature.
Use Kolormatrix PVA-SBQ emulsion within one year for best results.
Coated screens may be stored for up to one month when kept under the following conditions.
•  59° to 77° degrees F 
•  30% to 50% relative humidity