ATKINS THERMAL PROBE COMPLETE KIT

• Constructed of temperature-resistant Teflon^®, it may be used hundreds of times with-out degradation of material or accuracy of measurement.
• The wires are designed to make DIRECT CONTACT WITH THE INK. Many other temperature measuring devices are capable of reading only the temperature of the air around the screen printed item. The rise and fall of the ink temperature may be significantly different than that of the garment or the surrounding air.
• Response Time: 1 second, in liquid
• Auto Shut-off: Auto shut-off after 10 minutes of non-use
• Warranty: 5 year instrument warranty, 1 year probe
• Cable Length: 15 ft cable with Silicone outer jacket
• Certifications: NSF, CE, Rohs, Weee
• Temperature Range: -40° to 400°F (-40° to 205°C) with probe
• Temperature Accuracy: ±0.5F° (±0.3C°) over entire range at ambient temperatures between 68° to 86°F (20° to 30°C)
• Resolution: 0.1°
• Waterproof Rating: IPX7 Waterproof-rated
• Battery Life: 1800 hours typical, 2 AAA Alkaline batteries (included)

With the thermometer on and probe plugged in, place the "ring" over an inked part of a garment (or scrap piece of material) with the cross-hairs wires down. Be sure the wires are actually touching the ink. Allow the garment and probe to be fed into the dryer along the conveyor belt. The temperature displayed by the thermometer reflects the rise in temperature of the ink as it moves through the dryer. When the temperature begins to quickly decline, the probe should now have exited the dryer. Unplug the probe and allow only the lead wire to follow the probe through the dryer. DO NOT ALLOW THE THERMOMETER TO GO THROUGH THE DRYER and DO NOT PULL RING BACK as this could damage the delicate cross-hair wires.