ER-130 is a concentrated emulsion remover formulation designed for fast removal of diazo, photo polymer and capillary film emulsions. ER-130 may be applied by means of spray bottle, sponge, scrub pad or pump system application. ER-130 will increase reclaim efficiency and reduce time per screen by eliminating additional steps in the reclamation process.

ADVANTAGES
• Immediately breaks down hardened emulsion
• Non-hazardous
• Contains No VOCs
• No odor
• Safe on all types of mesh
• Concentrated for maximum economy

DIRECTIONS ER-130 can be used in concentrated form, or diluted up to 1:30 (chemical:water) depending on emulsion type and method of application. After determining proper ratio for your needs, mix contents in plastic container and fill with appropriate amount of water. Spray on ER-130 in a uniform pattern onto the print contact side of the screen. In some cases better results are obtained by applying ER-130 onto both sides of the screen. Allow to stand up to 3 minutes depending on the type and hardness of the emulsion. Remove the emulsion using a medium to high pressure cold water rinse. Flush the screen with a final rinse to remove any trace chemicals left on the screen. Allow to dry completely before recoating.

TYPICAL PRODUCT PROPERTIES
Appearance ------------------------------- Clear, colorless liquid
Odor---------------------------------------- None
pH ------------------------------------------ 3.5
Flash Point -------------------------------- None
Specific Gravity --------------------------- 1.07
Weight, per U.S. gallon ------------------- 8.9 lbs.
Stability ------------------------------------ Stable
DOT Shipping ----------------------------- Non-hazardous